Fujitsu ScanPartner SP30 Operator's Manual page 128

Chapter 8 Operational Settings
Item
Document check area
specification for Multifeed
Detection
(page 140)
Number of paper feeding retries
(page 137)
Life Counter Alarm Setting
(page 131)
Manual-feed timeout
(page 143)
Power SW Control
(page 145)
High Altitude Mode
(page 137)
Description
Selected range: Select this item to restrict the
area to run multifeed detection.
Enable / Disable (Middle): Specify whether to
enable or disable multifeed detection in the
selected area.
Start (Middle): Specify the start position of the
area in length (mm) from the leading edge of
the document.
End (Middle): Specify the end position of the
area in length (mm) from the leading edge of
the document.
Configure this setting to change the number of
feeding retries when a pick error occurs.
Specify the replacement cycle for the
consumables.
Select whether to disable or enable manual
feeding.
Paper-out detection time: Specify the waiting
time to cancel manual feeding.
Specify the method by which the scanner is
powered on/off.
Select whether to enable or disable high altitude
mode.
Enable to use the scanner at 2,000 m or higher
altitudes.
Parameter/Value
[Selected range] check box
Enable / Disable
(When [Selected range] is selected)
0 to 510 mm (in increments of 2)
0 to 510 mm (in increments of 2)
1 to 12 times
Pick Rollers / Brake Rollers:
10,000 to 2,550,000 sheets
(in increments of 10,000)
Disable / Enable
5, 10, 20, 30, 40, 50, 60, 70, 80, 90, 100, 110
(seconds)
Enable power switch / Disable power switch /
Enable USB power feeding
Enable / Disable
TOP
Contents
Factory Default
Index
Not selected
Introduction
Scanner
Disable
Overview
How to Load
0 mm
Documents
How to Use the
0 mm
Operator Panel
Various Ways to
7 times
Scan
Pick Rollers:
200,000 sheets
Daily Care
Brake Rollers:
200,000 sheets
Replacing the
Disable
Consumables
10 seconds
Troubleshooting
Enable power
switch
Operational
Settings
Disable
Appendix
Glossary
128