Advertisement
OPENING AND
CLOSING THE
SENSOR
• Loosen the retaining nut until the cable slides easily into
the grommet ;
• Partially unscrew the 2 front cover screws ;
• Pull out the front cover with the 2 front cover screws.
BRACKET
MOUNTING
WIRING
BROWN-GREEN Power supply
YELLOW
WHITE
PINK
BLACK
RED
BLUE
Ceiling mounting
SENSOR
DIMENSIONS
AND MOUNTING
75.5268.01 20070111
COM 1
NC 1
NO 1
COM 2
NC 2
NO 2
Wall mounting
2.5 in
5 in
6.25 in
Note: The bold-type values give the minimum distance required to be able to fully adjust the sensor.
• Connect the quick disconnect terminal block to the main electronic
circuit ;
• Slide the main electronic circuit into the 2 housing slot guides and
pull the main cable gently at the same time ;
• Gently push the front cover and make sure that the external
housing is properly seated (front cover must be flush with housing).
• Screw the 2 front cover screws and tighten the retaining nut.
5 in
6.25 in
•
Check that both locking
collars are at the same
position
•
Align the bracket slot to the
locking collar guide as shown
To insert or to remove the cable:
•
Unscrew the retaining nut
•
Pass the cable through the
retaining nut and the grommet
•
Screw the retaining nut
Bracket dimensions
Page 2 of 7
Advertisement
