Spring Clips Missing; Lock Led Flashes; Power Level 1 When Lock Icon Is Touched; Power Level Reduced Automatically When Burner Next To It Is Switched On - Miele KM 5773 Technical Information

Technical Information
Remedy:
Activate the signal tone (refer to Section 010-4.1).
Cause:
Timer was manually set to 00.
Remedy:
None.
3.43

Spring Clips Missing

Symptom:
The spring clips usually used to secure a cooktop are not there.
Cause:
These cooktops are simply placed into the cutout. Their high self-weight provides
sufficient pressure to ensure secure placement and sealing. The gap between
the ceramic surface and the countertop decreases over time.
Remedy:
None.
3.44

Lock LED Flashes

Cause:
L2 connection not connected/not present.
Remedy:
1. Check the power supply connection.
2. Connect the L2 wire correctly at the power supply connection.
3.45

Power Level 1 When Lock Icon Is Touched

Symptom:
When the lock $ touchpad is touched during operation, all switched-on burners
go to power level "1".
Cause:
Stop & go function is activated (factory setting).
Remedy:
Deactivate the stop & go function (refer to Section 010-4.1).
3.46 Power Level Reduced Automatically When Burner Next to It is
Switched On
Symptom:
When the front left burner is activated at any setting with the booster function, the
power level for the rear left burner is limited to 8 or less, and vice versa.
When the rear right burner is activated at any setting with the booster function,
the power level for the front right burner is limited to 8 or less, and vice versa.
Cause:
The maximum power consumption is limited to 3700 watts per power electronic.
The most recently made setting is carried out, but the burner already in operation
is limited.
Remedy:
40
KM 5773