MULTIQUIP Whiteman Series Operation Manual page 36

Pillow Block Bearings (Daily)
Perform the following lubrication procedure after every
8 hours of use.
1. Locate the Zerk grease fitting on either of the pillow
block bearings on the cross shaft assembly (Figure 28).
Remove the Zerk grease fitting cap and set it aside.
CROSS SHAFT
ASSEMBLY
Figure 28. Pillow Block Bearing Lubrication
2. Wipe the Zerk grease fitting clean to prevent abrasive
material from entering the fitting during lubrication.
3. Lubricate the Zerk grease fitting with one shot of
multipurpose grade grease. Replace the Zerk grease
fitting cap when finished.
4. Repeat steps 1–3 for the grease fitting on the opposite
side of the remaining pillow block bearing.
PAGE 36 — HHNG5 RIDE-ON TROWEL • OPERATION MANUAL — REV. #1 (07/05/18)
PILLOW BLOCK
BEARINGS
ZERK GREASE
FITTING
ZERK
FITTING CAP
Pitch Adjustment Levers (Monthly)
Perform the following lubrication procedure once a month.
1. Locate the Zerk grease fitting next to the knob on either
pitch adjustment lever (Figure 29). Remove the Zerk
grease fitting cap and set it aside.
ZERK
FITTING CAP
Figure 29. Pitch Adjustment Lever Lubrication
2. Wipe the Zerk grease fitting clean to prevent abrasive
material from entering the fitting during lubrication.
3. Lubricate the Zerk grease fitting with one shot of
multipurpose grade grease. Replace the Zerk grease
fitting cap when finished.
4. Repeat steps 1–3 for the grease fitting on the remaining
pitch adjustment lever.
MAINTENANCE
PITCH
ADJUSTMENT
LEVER
ZERK GREASE
FITTING