Connecting The Appliance - Siemens KT16R Series Instructions For Use Manual

en
Appliance ventilation
A ventilation cross section of
minimum 160 cm
installation below a worktop. For this
purpose, a vent measuring about
500 x 60 mm is required, which is
available from DIY shops or specialist
retailers.
S Mark the cut out for the vent on the
worktop centric to the appliance.
S Max. distance to wall 83 mm.
S Note width B" of the wall connection
rail!
S Saw out the cutout. Chamfer the
underside by approx. 4 mm.
S Insert and attach the ventilation grille.
Note:
The vent is not required when the
distance between the worktop and
appliance is more than 5 cm.
Prior to installation
Before the appliance is pushed into the
cavity, the tabs from the top cover strip
must be bent upwards; the tabs should
previously be lifted with a knife or similar.
Fig. 2/B
Appliance installation under worktop
Insert the appliance into the cavity until
the front edge of the appliance door is
flush with the furniture doors of the
adjacent cupboards.
Align the appliance with the
height adjustable feet until the upper
edge of the appliance is situated on the
worktop.
Adjust the height adjustable feet with a
wrench. Fig. 2/A
Fixing appliance to the worktop
Secure the appliance to the worktop with
standard chipboard screws.
6
2
is necessary for
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior of the
appliance (see chapter Cleaning the
appliance").
The socket should be freely accessible.
Connect the appliance only to 220 240
V/50 Hz alternating current via a correctly
installed earthed socket. The socket must
be fused with a 10 A to 16 A fuse.
If the appliance is to be operated in a
non European country, check whether
the stated voltage and current type on the
rating plate match the values of your
mains supply match the values of the
mains supply. The rating plate is situated
in the bottom left hand side of the
appliance. The power cord may be
replaced by a technician only.
Warning
!
Never connect the appliance to electronic
energy saver plugs or to power inverters
which convert the direct current to 230 V
alternating current (e.g. solar equipment,
power supplies on ships).