Table of Contents
Advertisement
Installation
Installation location
Install the appliance in a dry, well
ventilated room. The appliance should not
be installed in direct sunlight or near a
heat source such as a cooker, radiator,
etc. If installation next to a heat source is
unavoidable, use a suitable insulating
plate.
Observe the following minimum distances
to heat sources:
S 3 cm to electric or gas cookers.
S 30 cm to an oil or solid fuel cooker.
If the appliance is installed next to another
refrigerator or freezer, observe a minimum
lateral distance of 2 cm to prevent
condensation.
Aligning the appliance
Fig. 2/A
The appliance must be level. If the floor is
uneven, use the front height adjustable
feet.
Changing over the door
hinges
d Warning!
While changing over the door hinges,
ensure that the appliance is not
connected to the power supply. Pull out
the mains plug beforehand. Tilt back the
appliance (if required, place packaging
material, etc. underneath).
Fig. 3
The door hinges can be changed over if
required by the installation location.
Installation in numerical sequence.
Installing appliance
under worktop
After removing the worktop, the appliance
can be installed under a worktop.
Fig. 1
Removing the worktop
S Unscrew screws at the rear of the
worktop.
S Lift worktop slightly and remove.
en
5
Advertisement
Table of Contents
