Table of Contents
Advertisement
JOBNAME: 1st Edition PAGE: 40 SESS: 1 OUTPUT: Tue Jul 24 09:46:13 2007
6. After Steps 1 through 5 have been completed,
locate inside the garage the garage door opener
receiver (motor-head unit). Locate the "Learn"
or "Smart" button. The name and color of the button
may vary by manufacturer.
7. Firmly press and release the "Learn" or "Smart"
button. After you press this button, you will have
30 seconds to complete Step 8.
8. Immediately return to the vehicle. Firmly press and
hold the Universal Home Remote button, chosen in
Step 3 to control the garage door, for two
seconds, and then release it. If the garage door
does not move, press and hold the same button a
second time for two seconds, and then release
it. Again, if the door does not move, press and hold
the same button a third time for two seconds,
and then release.
The Universal Home Remote should now activate
the garage door.
To program the remaining two Universal Home Remote
buttons, begin with Step 2 of "Programming the
Universal Home Remote System." Do not repeat Step 1,
as this will erase all previous programming from the
Universal Home Remote buttons.
2008 - Saturn VUE Owner Manual (July 23, 2007)
Gate Operator and Canadian
Programming
If you have questions or need help programming the
Universal Home Remote System, call 1-800-355-3515 or
go to www.homelink.com.
Canadian radio-frequency laws require transmitter
signals to time out or quit after several seconds of
transmission. This may not be long enough for Universal
Home Remote to pick up the signal during programming.
Similarly, some U.S. gate operators are manufactured
to time out in the same manner.
If you live in Canada, or you are having difficulty
programming a gate operator or garage door opener by
using the "Programming Universal Home Remote"
procedures, regardless of where you live, replace Step
3 under "Programming Universal Home Remote"
with the following:
Continue to press and hold the Universal Home Remote
button while you press and release every two seconds
(cycle) the hand-held transmitter button until the
frequency signal has been successfully accepted by the
Universal Home Remote. The Universal Home Remote
indicator light will flash slowly at first and then rapidly.
Proceed with Step 4 under "Programming Universal
Home Remote" to complete.
117
Advertisement
Chapters
Table of Contents
