Sanyo RCS-BH80UA.WL Instruction Manual page 9

When you first turn on the ON/OFF operation button,
controller. During this blinking, the remote controller is verifying units connected. Use the remote
controller, after stops blinking.
G
L
K
D
P
H
1
A: When the unit is in the heating standby mode, the
Special Remarks on page 12.)
B: The currently selected operation mode is displayed.
C: This is displayed when a different operation mode was already selected by another remote control unit and
indicates that the mode cannot be changed.
D: When the TIMER SET button is pressed to set the timer, the
E: The currently selected FAN SPEED is displayed.
F: The currently selected Airflow Direction and SWEEP status are displayed.
G: This is displayed only when an abnormality occurs within a unit.
H: When the CHECK button is pressed, the TEST indicator appears.
I: This is displayed to indicate that the system controller is being used for control.
When is flashing on the display, the operation is not accepted by the system controller.
J: This indicates the indoor unit address in case of group control.
Unit No.
1 — 2
Indoor unit No.
Refrigerant circuit No.
K: This is displayed when it is time to clean the filter.
L: When setting the timer, the selected timer mode is displayed.
M: This indication appears when the temperature is set.
N: This indication appears when the remote control sensor is used.
O: This indication appears when the ventilation fan does not operate even if the ventilation button has been
pressed.
P: This indication appears when the ventilation fan is operating.
1 - 8
Display (Remote Control Unit)
B
will blink on the display of the remote
F C I J
Description
indicator appears. (Refer to the description of the
indicator flashes.
M
N
A
O
E