Sanyo RCS-BH80UA.WL Instruction Manual page 17

How to remove the filter
How to remove the filter (continued)
Ceiling-mounted type (T):
Wall-mounted type (K):
1
1 - 16
Care and Cleaning (continued)
(continued)
4. Remove the air filter attached to the air intake grille.
Air intake
grille
1. Remove the bolt screws on the finger-hold using a screw driver. (After
cleaning, be sure to attach the two bolt screws.)
2. Take hold of the finger-hold on the air intake grille and slide it to the rear,
and the grille will open downward.
3. Take hold of the finger-hold on the air filter, first lift it and then pull it
toward you to release it from the catch.
for KHH2672R, KH3072R, KH3672R
1. Move the flap on the air outlet grille to its lowest position with the remote control unit.
2. The filter is disengaged by pushing the tab up gently. Hold the air filter by the tab
at the bottom, and pull downward.
1 Push up
then
2 Pull down
When replacing the filter, make sure that the FRONT mark is facing you.
Push it up until you hear it click back into position.
1.
Move the flap on the air outlet grille to its lowest position with the remote control unit.
2. The filter is disengaged by pushing the tab up gently. Hold the air filter by the tab
at the bottom, and pull downward.
Air intake grille
When replacing the filter, make sure that the FRONT mark is facing you.
Push it up until you hear it click back into position.
Latch
Safety chain
Bolt screw
Finger-hold
Air filter
Air filter finger-hold
for KH2672
Air filter
Air filter
Catch
Air intake grille
Air filter