Sanyo C4272R Service Manual page 169

Setting mode 2
<Operating procedure>
(1) Press and hold the button,
seconds or longer.
(2) Use the temperature setting
item codes and setting data are shown in the table below.
(3) Use the timer time and
To confirm the changed setting data, press the
(At this time, "Setting" stops blinking and remains lit.)
(4) During this mode, "Setting" is displayed, blinking. The display shows the set
outdoor unit address "System XX-YY" (System XX = System address, YY =
Address at outdoor unit sub-bus), item code number (DN value in the table
below), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The display changes between the first 3 digits (Fig.
digits (Fig. ). When the first 3 digits are displayed, the top point of the colon is lit.)
B
(5) To end the setting mode, press the
(5)
button, and button simultaneously for 4
and buttons to change the item code. The
buttons to change the setting data.
button.
button. The display returns to the normal display mode.
A D s i l p y a o f f s r i 3 t d g i s t i
(1) (3)
80: <Refrigerant type> A and B are displayed alternately. (Example shows 000 410 (R410A).)
5. Outdoor unit maintenance remote control
D s i l p y a o l f s a 3 t d
B
(2)
V-9
(5)
(1) (3)
) and the last 3
A
g i s t i
SM831148
(2)
1
2
3
4
5
6