Make The Network Settings On The Printer - Roland VersaUV LEF-200 First Step Manual

5.
Select [Use the following IP address].
6.
Enter the information as shown below, then
click [OK].
Parameter
IP address
Subnet mask
Here, "XXX" can be any number from 001 to
254. However, be sure to specify a number
that is different from the numbers used for
other computers and devices. Here, as an
example, enter "192.168.0.101" for the IP
address and "255.255.255.0" for the subnet
mask.
7.
Click [Close] in [Ethernet Properties] ([Local
Area Connection Properties] on Windows
7), and then click [Close] in [Ethernet Status]
([Local Area Connection Status] on Windows
7).
Address to enter
192.168.0.XXX
255.255.255.0
Prepare for Using This Printer
Make the Network Settings on the
Printer
NOTE
The addresses used in this section are
merely example settings. For detailed
information about the settings, consult your
network administrator.
1. Set the IP address.
1.
Press [MENU].
2.
Press [ ] several times to display the screen
shown below.
MENU
SYSTEM INFO.
3.
Press [ ], then [ ].
The screen shown below appears.
SYSTEM INFO.
NETWORK
4.
Press [ ] three times.
The screen shown below appears.
IP ADDRESS
192.000.000.000
5.
Press [ ] or [ ] to select the address number.
6.
Press [ ].
7.
Repeat steps 5 and 6 to set [IP ADDRESS]
(192.168.000.XXX).
Here, "XXX" can be any number from 001 to
254. However, be sure to specify a number
that is different from the numbers used for
other computers and devices.
For the part corresponding to "192.168.000,"
apply the same value as the setting of your
computer.
Here, "192.168.000.003" is entered by way of
example.
IP ADDRESS
192.168.000.003
33