Adjusting The Separation Roller Gap - Canon imageFORMULA CR-L1 User Manual

O
Click [OK] to close the scanner properties.
NOTE
You can reset the Residual ink from the Scanning Utility. Click [About], and then click
[Reset] on the setting dialog box. (See Step 5 on p. 20)

Adjusting the Separation Roller Gap

If double feed should occur too often, adjust the Separation Roller gap
according to the following procedure.
IMPORTANT
• Make sure that the size, thickness, and weight of your document meets the
conditions of this scanner. See "Document," on p. 22.
• Your unit has been carefully adjusted to meet most conditions. However, the below
adjustment may be needed depending on your environment (humidity,
temperature, etc.) and the documents you are scanning (checks, etc.). Perform the
adjustment only if necessary.
A
Hook your finger around the open lever and open the Maintenance
Cover.
B
Pull out the document feed tray.
C
Load two checks or check-stock paper together.
D
Slide the two sheets through between the feeding roller and the
separation roller and stop at the position shown below.
NOTE
If you were unable to slide both sheets through the gap between the rollers, turn the
paper thickness adjustment dial counter-clockwise (left) until both sheets two pieces
easily slide through the gap.
E
Gently remove one of the sheets.
40
Separation Roller
Feeding Roller
Paper Thickness
Adjustment Dial
Two Sheets