Canon imageFORMULA CR-L1 User Manual page 33

C
Spin the rollers while wiping them clean with a firmly wrung cloth
dampened with water or a mild detergent.
There are 18 roller positions, as shown in the diagram below.
NOTE
• Use cotton swabs to clean the rollers in locations that are too narrow for your
fingers, such as A, B, J, N, O, and P.
• Rollers in positions B, D, E, K, and P are turned by the roller in position E. Turn
the roller in position E to wipe the rollers.
• Rollers in positions M and N comprise two rollers each, an upper roller and a lower
roller.
• Do not force the rollers if they will not turn. In this case, wipe dirt only off of the
exposed area.
D
Use cotton swabs to clean the entire scanning glass. There are two
scanning glass areas, one on each side. Use a cotton swab to wipe
dirt from the entire surface of each.
IMPORTANT
Scratches on the scanning glass may cause marks on the images and could cause
feeding errors. If there are scratches on the scanning glass, contact your local
authorized Canon dealer or service representative.
E
Gently close the reading unit until it clicks into place.
F
Gently close the maintenance cover until it clicks into place.
33
Scanning
Glass