Table of Contents
Advertisement
B.
Place the Power OFF-ON switch in the ON position
and push the CLEAN button to rotate the auger.
Allow the mix to agitate in freezer barrel until the
mix has become a liquid, about 5 minutes.
C.
Empty mix from the freezer by opening the spigot
and draining into a tall cup and discarding mix.
Continue drawing mix into the cup until the freezer
is empty.
D.
Fill a clean and sanitized tall cup with clean 110°F
(43°C) water and submerge blender agitator shaft
into water. Activate blender by pulling spigot to the
right. Allow blender agitator to run for 10-15
secondes. Repeat using a mild detergent.
E.
Push the CLEAN button to stop the auger rotation.
F.
Place the Blender Power OFF-ON switch into the
OFF position and unplug the blender from the
freezer.
G.
Place the Power OFF-ON switch inthe OFF
position.
Figure 3-5 Removing Blender
H.
Remove the knobs on the front door and remove
the blender assembly and set aside (Fig. 3-5).
When the knobs are removed, mix may drip from
the door and barrel into the drip tray.
Support the blender with one hand while removing
the knobs on the door to prevent the blender from
dropping.
J.
Replace the door knobs on the front door.
NOTE
K.
Remove the clear plastic swing shield from the
blender assembly and clean it (Refer to Section
3.9 - Cleaning the Freezer Parts).
3.7
CLEANING THE FREEZER
The frequency of cleaning the freezer and freezer
parts must comply with local health regulations.
After the mix has been removed from the freezer, the
freezer must be cleaned. To clean the freezer, refer to the
following steps:
A.
Close the spigot and fill the hopper with 2 gallons
(7.5 liters) of tap water.
B.
Place the Power OFF-ON switch in the ON position
and press the CLEAN button. The auger will start
to rotate.
C.
Allow the water to agitate for approximately 5
minutes.
If freezer is left in CLEAN for more than 20 minutes,
the display will show an error code.
D.
Open the spigot to drain the water. Remember to
place a bucket or container under the spigot to
catch the water. When the water has drained, turn
the Power OFF-ON switch to the OFF position.
Allow the freezer barrel to drain completely.
E.
Repeat Steps A through D using a mild detergent
solution.
3.8
DISASSEMBLY OF FREEZER PARTS
Hazardous Moving Parts
Revolving auger shaft can grab and cause injury.
Place the Power OFF-ON switch in the OFF posi-
tion before disassembling for cleaning or servicing.
Inspection for worn or broken parts should be made each
time the freezer is disassembled. All worn or broken parts
should be replaced to ensure safety to both the operator
and the customer and to maintain good freezer perfor-
mance and a quality product. Frequency of cleaning must
comply with the local health regulations.
To disassemble the freezer, refer to the following steps:
A.
Remove hopper cover and drain tray.
B.
Remove the mix inlet regulator from the hopper by
pulling straight up.
C.
Remove the front door by turning the circular
knobs and then pulling the front door off the studs.
11
NOTE
NOTE
CAUTION
Advertisement
Table of Contents
