If Errors Occur; Error Messages And Troubleshooting - Ricoh Ri 100 User Manual

If Errors Occur

Error Messages and Troubleshooting

• Keep ink and ink containers out of reach of children.
• If ink gets into contact with eyes, wash eyes immediately with run-
ning water. Consult a doctor if necessary.
• When replacing ink, avoid getting ink on your skin. If ink comes
into contact with your skin, wash the affected area thoroughly with
soap and water.
• Be sure to locate the machine as close as possible to a wall outlet.
This will allow easy disconnection of the power cord in the event
of an emergency.
• Do not open the cover while the machine is operating. Doing so
might cause your hand or fingers to get trapped in the machine,
and an injury might occur.
Error Messages and Troubleshooting
Error Messages
Adjust height, press Start
3
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Auto Head Maint. Required.
Cannot use High Temp. /
Power Off On
Cannot use Low Temp. /
Power Off On
30
Troubleshooting
Wrinkles, slack or a float remain on the fabric or
the edges of the fabric are out of the tray. De-
t a c h t h e t r a y, a n d t h e n l o a d t h e f a b r i c a g a i n .
If the message reappears, adjust the height of the tray
manually.
Fabric that is 4 mm (about 0.2 inches) or thicker is load-
ed on the A4 standard tray or A5 tray. Load fabric that is
up to 4 mm (about 0.2 inches) thick on the A4 standard
tray or A5 tray.
Regular maintenance is needed. Clean the print head
nozzles.
Usually it is displayed once every one or two weeks.
Even if the frequency of use is low, it is always displayed
once every four weeks.
The temperature is abnormally high or low. Check the
installation area and relocate the machine. Alternatively,
wait until the machine acclimates to the room tempera-
ture.