Answering A Scap Call; Bridge In To An Active Scap Call; Leave A Bridge Scap Call; Make An Active Scap Call Public - Polycom VVX 150 User Manual

When a member places a call on the shared line, the other members are notified with a steady red LED
light on the line key on members' phones. Multiple group members can place outgoing calls while a call is
in progress on the shared line.

Answering a SCAP Call

Any incoming call to the shared line rings on all group members' phones simultaneously; the call is
displayed on all members' screens, and a green LED light flashes on the line key.
Any group member can respond to an incoming call to the shared line. When a group member answers
an incoming call, the line key's LED indicator on all phones changes to a steady red light to indicate the
call was answered. Members can also view the status of a call on the shared line by pressing and holding
the corresponding line key for one second. The call's status and the Bridge In soft key display for five
seconds.

Bridge In to an Active SCAP Call

Multiple group members can bridge in to one call if the call is public. After a group member bridges in to a
call, the call becomes a bridge call—a call between two or more SCAP members and another party.
Ask your system administrator about the maximum number of participants allowed on a bridge call.
If the call is private or if bridging is disabled, the Bridge In soft key does not display or you cannot bridge
in to active calls answered by other group members.
Procedure
1. Press and hold the line key with the active call for one second.
2. Select Bridge In.
If enabled, a bridge tone plays notifying the other call participants that you are bridging in on the
call.

Leave a Bridge SCAP Call

Any member in a bridge call can leave the call, and the call remains active.
Procedure
1. Select the End Call soft key or place the handset in the cradle.
Your connection to the bridge call is ended, and the other call participants remain on the call.
You can rejoin a bridge call after leaving by pressing the Bridge In soft key again.

Make an Active SCAP Call Public

By default, all active calls on the shared line are private. After a call is answered, you can make the call
public and enable other SCAP members to bridge in to the active call.
Procedure
1. During an active call, select Share.
The call is now public, the Private soft key is displayed, and other group members can bridge into
the call.
Polycom, Inc.
Shared Lines
61