Connecting The Terminal Power Pack; Charging The Battery - VeriFone e280 Installation Manual

Connecting the
Terminal Power
Pack
CAUTION
WARNING
To Connect the
Terminal Power
Supply
TIP
Charging the
Battery
Connect the e280 device to the provided USB cable and insert the other end into
any USB charger head for initial charging.
Using an incorrectly rated power supply may damage the device or cause it not
to work as specified. Before troubleshooting, ensure that the power supply being
used to power the device matches the requirements specified on the bottom of
the device. (See Specifications
use any standard USB charger.
Do not plug the power pack into an outdoor outlet or operate the device outdoors.
During a transaction, disconnecting the power by unplugging the device from a
wall power while at very low battery charge may cause
yet stored in the device memory to be lost.
Each e280 device comes with a power supply cable, USB to USB-C cable is used
to connect the device directly to an USB outlet to charge the battery. The e280
unit is equipped with an USB capable universal input.
1
Insert the USB-C plug into the USB-C port of the e280, as shown in the figure
below.
Figure 4 e280 Power Supply Connection
2
Plug the USB cable into a USB wall outlet or the output of a standard USB
power supply.
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.
After unpacking your e280 device, connect the power pack to the unit for eight
hours or until fully charged.
•
Charge the e280 device for eight hours before initial use.
for detailed power supply specifications.) You can
D
EVICE

Connecting the Terminal Power Pack

transaction data files not
280 I G
E NSTALLATION UIDE
S
ETUP
17