BellSouth MH9932 Installation Instructions & Owner's Manual page 6

FOR BASE UNIT BATTERIES:
5. Do not attempt to recharge the battery(ies) identified for use with this
product. The batteries may leak corrosive electrolyte or explode.
6. Do not attempt to rejuvenate the battery(ies) identified for use with this
product by heating them. Sudden release of the battery electrolyte may
occur causing burns or irritation to eyes or skin.
7. When replacing batteries, all batteries should be replaced at the same
time. Mixing fresh and discharged batteries could increase internal cell
pressure and rupture the discharged battery(ies). (Applies to products
employing more than one separately replaceable primary battery).
8. When inserting batteries into this product, the proper polarity or direction
must be observed. Reverse insertion of batteries can cause charging,
which may result in leakage or explosion. (Applies to product employing
more than one separately replaceable primary battery).
9. Remove the batteries from this product if the product will not be used
for a long period of time (several months or more) since during this time
the battery could leak in the product.
10. Discard "dead" batteries as soon as possible since "dead" batteries are
more likely to leak in a product.
11. Do not store this product, or the battery(ies) identified for use with this
product, in high temperature areas. Batteries that are stored in a freezer or
refrigerator for the purpose of extending shelf life should be protected from
condensation during storage and defrosting. Batteries should be stabilized
at room temperature prior to use after cold storage.
FOR HANDSET BATTERY
12. Change the battery pack provided with or identified for use with this
product only in accordance with the instructions and limitations specified
in this manual.
SAVE THESE INSTRUCTIONS
6