Recharging The Battery Pack - BellSouth MH9932 Installation Instructions & Owner's Manual

Recharging the Battery Pack

Battery Type
Use the following type and size battery pack:
Cordless Telephone Battery Pack
3.6V, 600mAh
U.S. Electronics Inc.
Ni-Cd Battery Pack: model B650
This battery pack is available through:
U.S. Electronics Service Center
105 Madison Avenue
New York, NY 10016
1-800-338-1694
Recharging the Battery Pack
The nickel cadmium (Ni-Cd) batteries in the HANDSET can be recharged
many times using the built-in charger in the BASE UNIT.
When the battery is low, a "beep" sound will be heard every 12 seconds.
This indicates that the battery pack needs to be recharged.
Charge the batteries at least once every 90 days of non-use to avoid
battery failure. When the battery pack can no longer be charged, replacement
of the battery pack will be necessary.
The battery pack used in your telephone may develop a condition known as
"MEMORY". Once subjected to a regular short discharging routine, the
battery assumes the discharging pattern it was subjected to. This is known as
a "MEMORY" condition which causes rapid discharging shortening the battery
charge span. If you believe your battery has developed a memory condition,
do not charge the HANDSET until the battery low warning starts beeping.
When it does come on, charge the HANDSET fully for 12 hours.
IMPORTANT
In order to get maximum life from
the HANDSET battery pack, be
sure to charge the HANDSET
for 12 hours before initial use.
47
Ni-Cd