Table of Contents
Advertisement
Instant T
imer Recording
Instant T
imer Recording
With this feature you can record for a preset length
without using the program timer.
1. Turn on DVD+VCR and the TV.
2. Be sure the TV is tuned to the DVD+VCR output
channel (CH 3 or 4). If a direct VIDEO/AUDIO
connection is made between the DVD+VCR and
the TV, set the TV's source selector to VIDEO.
3. Insert a video cassette with the safety tab intact.
4. Select the desired channel using CH/TRK (v/V)
or the number buttons (0-9). The channel number
appears on the TV screen. If you are recording
from another source via audio/video input jacks
(at the rear or front panel), select LINE1 (rear
jacks) or LINE2 (front jacks) by using INPUT.
5. Set the desired recording speed (SP or SLP)
using SPEED. The tape speed appears on the TV
screen.
6. Press REC/ITR (z) twice. The menu appears on
the TV screen, recording starts, and the
(TIMER) indicator lights.
INSTANT TIMER RECORD
CHANNEL
SPEED
START
LENGTH
7. Press REC/ITR (z) repeatedly to select the
recording time length. Each time you press this
button the recording time increases 30 minutes
(up to 9 hours). If you set the time to 0H00M, the
DVD+VCR goes into the normal recording mode.
8. Stop the recording by pressing STOP (x) If you
don't press stop, at the end of the recording, the
DVD+VCR stops and shuts off.
Note:
During Instant Timer Recording, you cannot change the
channel on the DVD+VCR.
Checking the Recording Time
Press REC/ITR (z) once to check the recording time.
The recalled setting automatically returns to the TV
screen after 6 seconds.
24
2
SP
NOW
0H30M
Extending the Recording Time
The recording time can be extended anytime by
pressing REC/ITR (z). Subsequent presses result in
advancing the recording time by 30-minute incre-
ments.
Note:
If you press PAUSE/STEP (X) during instant timer record-
ing, the instant timer recording is cancelled.
Dubbing and Editing
Dubbing and Editing
You can edit or dub your camcorder or another
VCR's recordings to this DVD+VCR using the rear
or front panel-mounted Audio and Video (A/V) input
jacks. These direct A/V jacks provide better picture
results than using the RF jack on the rear panel.
1. Connect the camcorder's / other VCR's A/V
outputs to your DVD+VCR.
2. Set the input channel to LINE2. (press INPUT
twice to select LINE2) unless you have connected
your DVD+VCR to the A/V input jacks on the rear
of DVD+VCR. In this case, select LINE1.
3. Play the tape in the camcorder or other VCR. If
you have a TV attached to your DVD+VCR, you
can see the video playing.
4. When you want recording to begin, press
DVD+VCR's REC/ITR (z) once to start.
Note:
Before recording, confirm the recording start position.
Advertisement
Table of Contents
