Music On Hold - AT&T PARTNER Plus Installation And Programming Manual

Music On Hold

3-30 System Programming
Code: #602
Description: Activates or deactivates the Music-on-Hold jack on the processor
module. To provide music or taped messages to callers on hold, the Music-on-
Hold jack must be active and an audio source attached to the jack.
Valid Entries: 1 = Active
2 = Not active
Considerations:
If no audio source is attached to the system, we recommend changing the
setting to "not active."
If the audio source develops trouble (such as a bad tape), you can quickly
turn it off by setting the jack to "not active" until you are able to solve the
problem.
Users of equipment that rebroadcasts copyrighted music or other material
may be required to obtain a license from a third party such as ASCAP or
BMI.
Programming Steps:
Press Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 6 ] [ 0 ] [ 2 ]. The
1. [
display reads:
Music On Hold
1 Active
2. To deactivate the music-on-hold jack, press [ Next Data ] until the display
reads:
Music On Hold
2 Not Active
= Factory Setting
To go to the next procedure: [ Next Proc ]
To go to the previous procedure: [ Prev Proc ]
To return data to the factory setting: [ Remove ]
To go to a specific procedure: [ # ] [ x ] [ x ] [ x ] [ x ]. The
(where XXX is the procedure number)
To exit system programming: [ Feature ] [ 0 ] [ 0 ]