Programming Procedures - AT&T PARTNER Plus Installation And Programming Manual

Programming Procedures

System Date
If your system has been previ-
ously programmed, the displays
may differ.
See the box at the bottom of this
page for a summary of options of
what to do next.
System Day
3-4 System Programming
Code:
#101
Description: The month, day, and year that appears on PARTNER display
phones
Valid Entries: Any date
Programming Steps:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 1 ] [ 0 ] [ 1 ] .
display reads:
System Date
Data 010100
2. Enter today's date in the form MMDDYY, using leading zeroes for all
single-digit months and dates. For example, to enter December 4, 1990,
press [ 1 ] [ 2 ] [ 0 ] [ 4 ] [ 9 ] [ 0 ] . The display reads:
System Date
Data 120490
Code: #102
Description: The day of the week that appears on PARTNER display phones
Valid Entries: 1 = Sunday
2 = Monday
3 = Tuesday
Programmi ng Steps:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 1 ] [ 0 ] [ 2 ] .
display reads:
System Day
1 Sun
2. Change the day by entering a new setting number as listed above.
example, to set the day to Tuesday, press [ 3 ]
System Day
3 Tue
Or press [ Next Data ] or [ Prev Data ] until the correct day of the week shows on the
display.
= Factory Setting
Togo to the next procedure: [ Next Proc ]
Togo to the previous procedure: [ Prev Proc ]
To return data to the factory setting: [ Remove ]
4 Wednesday 6 = Friday
=
7 = Saturday
5 = Thursday
.
The display reads:
To go to a specific procedure: [ # ] [ X ] [ X ] [ X ]
(where X X X is the procedure number)
To exit system programming: [ Feature ] [ 0 ] [ 0 ]
For