Quick Setup; Activating Sitrans Probe Lu; Setting The Profibus Address Via The Handheld Programmer - Siemens Sitrans PROBE LU Instruction Manual

Quick Setup

Activating SITRANS Probe LU

Keep infrared devices such as laptops, cell phones, and PDAs, away from
Note:
SITRANS Probe LU to prevent inadvertent operation.
Power up the instrument. SITRANS Probe LU starts in RUN mode, and the LCD displays
the output of AIFB1.

Setting the PROFIBUS address via the handheld programmer

Notes:
• Local programming must be enabled, to allow changes. (In PDM, go to Identification
> Device > Local Operation Enable and select the desired setting.)
• CLEAR can be used to clear the field.
C
• Press Right ARROW
• Press Left ARROW
PROGRAM icon is not visible).
1. Press Mode
mode and open Menu level 1.
2. Press Right ARROW
to PROFIBUS address.
3. Press Right ARROW
mode: the PROGRAM icon will flash.
4. Key in a new value and press Right ARROW
to accept it.
The LCD displays the new value; PROGRAM
icon disappears, and the last menu digit
flashes to indicate Navigation mode.
5. Press Mode
1.
Default address is 126.
7ML19985JB02 SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL
to open Edit mode: the PROGRAM icon flashes.
to cancel Edit mode: the Menu number flashes (the
to activate PROGRAM
twice to navigate
again to open Edit
to return to RUN mode.
Menu level: last
digit flashes in
Navigation mode.
Program icon:
flashes in Edit
mode.
Right-most digit
flashes in
Navigation
mode.
1
Page 19