Common Windows Problems - Samsung CLP-510 Series Setup Manual

Message
Transfer Belt
Error
Tray2 Error
Tray2 Jam
Cover Open
Waste Motor
Error
Replace/Install
Waste Toner Tank
Problem
"File in Use" message
appears during installation.
"Error Writing to LPTx"
message appears.
"General Protection Fault",
"Exception OE", "Spool32",
or "Illegal Operation"
messages appear.
"Fail To Print", "A printer
timeout error occurred."
messages appear.
7.30
S P
OLVING ROBLEMS
Status
The transfer belt is either
not working or not
correctly installed in the
printer.
Optional Tray2 is not
properly installed or
connected to the printer.
Tray2 jam cover is open.
A problem has occurred in
the waste toner motor.
The waste toner container
is full.

Common Windows Problems

Exit all software applications. Remove all software from the
StartUp Group, then restart Windows. Reinstall the printer
driver.
• Ensure that the cables are connected correctly and the
printer is on.
• If bi-directional communication is not turned on in the
driver, it will also cause this message.
Close all other applications, reboot Windows and try
printing again.
These messages may appear during printing. Just keep
waiting until the printer finishes printing. If the message
appears in standby mode or after printing is complete,
check the connection and/or whether an error occurred.
N
: Refer to the Microsoft Windows 9x/Me/NT 4.0/2000/2003/
OTE
XP User's Guide that came with your PC for further information on
Windows error messages.
Replace the transfer belt.
OR
Make sure the installed transfer belt
is properly seated.
After turn the printer off and then
back on, reinstall the optional tray2.
If the message persists, contact a
service representative.
Close Tray2 cover firmly.
Contact a service representative.
Replace the waste toner container
with a new one. See page 6.11.
Possible Cause and Solution
Do this...