Understanding Display Messages - Samsung CLP-510 Series Setup Manual

Problem
Curl
Message
ADC Not
Confirm Error
Cover Open
[Color] Toner
Empty
Dev. Motor
Error
Engine Fuser
Low Heat Error
Engine Fuser
Over Heat Error
7.26
S P
OLVING ROBLEMS
If the printed paper is curled or paper does not feed into the
printer:
• Turn the stack of paper over in the paper tray. Also try rotating
the paper 180° in the tray.

Understanding Display Messages

Messages appear on the control panel display to indicate the
printer's status or errors. Refer to the tables below to
understand the messages' meaning and correct the problem if
necessary. Messages and their meanings are listed in
alphabetical order.
N
: When you call for service, it is very helpful to tell the
OTE
service representative the display message.
Status
A problem has occurred in
the ADC in the printer.
The top cover is open.
The corresponding toner
cartridge in your printer is
empty and the printer
working.
A problem has occurred in
the development motor of
the printer.
The temperature in the
fuser is abnormally low.
The temperature in the
fuser is abnormally high.
Solution
Do this...
Contact a service representative.
Close the top cover firmly.
Replace the corresponding toner
cartridge with a new one. See
page 6.8.
Unplug the power cord and plug it in
again. If the problem persists, call for
service.
Unplug the power cord and plug it in
again. If the problem persists, call for
service.
Unplug the power cord and plug it in
again. If the problem persists, call for
service.