Table of Contents
Advertisement
When Driving
i-ACTIVSENSE
▼ Stop Hold Control
While in headway control using the MRCC with Stop & Go function system, your vehicle
will stop when a vehicle ahead stops. When the vehicle is stopped and the stop hold control
operates, the MRCC with Stop & Go function indicator light turns on.
NOTE
If the MRCC with Stop & Go function system is cancelled during stop hold control, the
•
vehicle is held in its stopped position. The stop hold control can be cancelled by
performing one the following actions.
Press the accelerator pedal and resume driving the vehicle.
•
While forcefully depressing the brake, switch the MRCC with Stop & Go function
•
system off.
The parking brake is automatically applied and the vehicle is held in its stopped position
•
when 10 minutes have elapsed since the stop hold control operated. At this time, the
MRCC with Stop & Go function system is cancelled.
If the i-stop operation conditions are met during stop hold control, the engine stops even
•
though the brake pedal is not depressed.
Refer to i-stop on page 4-11.
The brake lights turn on during stop hold control.
•
To resume driving
After the vehicle ahead starts moving while your vehicle is stopped under stop hold control,
press the RES switch or depress the accelerator pedal to cancel the stop hold control and
resume driving.
4-122
CX-8_8GF4-EO-18D_Edition1
2018-3-6 19:38:07
Advertisement
Table of Contents
