Mounting Hole Centers (All Models) - Jet JDP-20VS-3 Operating Instructions And Parts Manual

Main materials
Head
Table and Base
Spindle and Quill
Column
Dimensions
Assembled machine dimensions LxWxH
Shipping dimensions LxWxH
Weights
Net weight
Shipping weight
1
Subject to local and national electrical codes.
2
The specified values are emission levels and are not necessarily to be seen as safe operating levels. As workplace
conditions vary, this information is intended to allow the user to make a better estimation of the hazards and risks
involved only.
L = length, W = width, H = height
n/a = not applicable
The above specifications were current at the time this manual was published, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.

4.1 Mounting hole centers (all models)

JDP-20VS-1
38.18 x 27.16 x 79.52 in. (970 x 690 x 2020 mm)
37 x 25.5 x 75 in. (940 x 648 x1905 mm)
Table 1
Figure 4-1: machine base mounting
7
JDP-20VS-3 JDP-20VST
cast iron
cast iron
steel/cast iron
steel
685 lbs. (311 kg)
780 lbs. (354 kg)