Dometic MAGICCOMFORT MSH300 Installation And Operating Manual page 16

Installing the seat heater
Installing the heating element for the seat surface
➤ Insert the heating element for the seat surface between the cover fabric and the
foam core of the seat (fig. b, page 5).
➤ If anchoring grooves are present, make sure that the cut-out sections are
positioned over the anchoring grooves (fig. c, page 5) and place the heating
elements in the anchoring grooves.
➤ Fasten the heating element using double-sided adhesive tape to prevent it
sliding on the foam core.
Ensure that no creases or kinks form.
Installing the heating element for the backrest
A
NOTICE!
If the seats are equipped with side airbags, then there is a
predetermined breaking point in the cover fabric. The seat cover must
therefore not be pulled tightly or slip out of place.
➤ Open the lower area of the backrest cover (fig. d, page 5).
➤ Push the heating element into the gap between the seat cover and the seat
cushion (fig. e, page 5).
➤ Fasten the heating element using double-sided adhesive tape to prevent
creases.
Installing the seat
➤ Reassemble the backrest and seat.
➤ Lift the seat into the vehicle.
➤ Secure the vehicle seat with the fastening screws.
16
MSH300
EN