Dometic MAGICCOMFORT MSH300 Installation And Operating Manual page 14

Installing the seat heater
6.2 Installing the seat heater
Removing the seat
➤ Secure the vehicle against rolling away.
A
NOTICE!
For vehicles with side air bags in the seat backrest, observe the
manufacturer's instructions on removing the seats and the upholstery.
➤ Check the suitability for installation using these installation instructions and the
manufacturer's information.
➤ Remove the fastening screws from the vehicle seat.
➤ Lift the seat out of the vehicle.
Preparing the seat
➤ Remove all plastic panelling from the seat to ensure the fastening of the cover
fabric can be reached.
➤ Separate the backrest from the seat (fig. 7, page 5 and fig. 8, page 5).
➤ Open the seat cover on the seat surface.
The cover fabric is usually tucked into a seam on the frame with a wide cardboard
strip or metal wire.
➤ Remove the fasteners using a screwdriver and pliers (fig. 9, page 5 and fig. 0,
page 5).
➤ Remove any upholstery staples or cross braces (fig. a, page 5).
➤ Open the cover of the backrest in the same way.
14
MSH300
EN