3-7) Network Setup Function And Setting Method - Samsung SMO-150QN User Manual

3-7) NETWORK SETTING function and setting method
This section of the manual is intended for users who will install this security system in a network
environment.If you have difficulty setting the network,we recommend contacting your network administrator.
• Static
• DHCP
• DSL (PPPoE)
• Function: Allows users to select the STATIC (fixed) IP, DHCP, PPPoE of Setting.
Setting method: Move to #7, NETWORK SETUP MENU by using ▲/▼ KEY in the SETUP
•
MENU, then press the ENTER SWITCH to display the OSD as shown in the figure below.
(The figure shows the initial setting status)
06/01/03
NETWORK SETTING
1. NETWORK ACCESS
2. HTTP PORT
NETWORK STATUS
IP
GATEWAY
SUBNETMASK
DNS 1
DNS 2
MAC ADDR
MOVE TO EACH item by using ▲/▼ KEY, and using œ œ / √ √ KEY to change the set value.
Static IP User
- Constituted by Static IP on the TCP/IP network
1) Move to 'STATIC...' by using ▲/▼ KEY at NETWORK ACCESS, then press ENTER SWITCH
to set STATIC...
(STATIC : Select in case the network configuration of monitor is fixed IP (Public or Private IP)
06/01/03
STATIC ACCESS
IP
GATEWAY
SUBNETMASK
DNS 1
DNS 2
2) Move to IP ADDR / GATEWAY / SUBNETMASK by using ▲/▼ KEY.
3) Press ENTER SWITCH and type in IP ADDR / GATEWAY / SUBNETMASK respectively.
4) DNS 1 and DNS 2 will be automatically set to DNS as shown above.
Use œ œ / √ √ KEY to change it.
13:14:00
STATIC.../DHCP.../PPPoE...
00080
ADDR 192.168.1.200
192.168.1.65
255.255.255.0
168.126.63.001
168.126.63.002
00:30:6f:ff:00:00
13:14:00
ADDR 192.168.1.200
192.168.1.65
255.255.255.0
168.126.63.001
168.126.63.002
Eng-41