Table of Contents
Advertisement
2) INSTALLING THE PIR CAMERA (SOC-P120)
1. Choose an installation site that can
sufficiently support 5 times the weight
of the equipment to be installed.
2. Remove the screw (BH M2.6) at the
bottom of the main unit by turning it
counterclockwise, and then lift the
assy-case front as you push it upward
to detach it from the case-rear.
(❊ Do not apply excessive force, as
doing so may damage the internal
assembly.❊)
3. Place the case-rear over the installation
site and mark screw holes with a pencil
(indicated by the circles in the
illustration). Drill a pilot hole for each
pencil mark (0.2 inch in diameter and at
least 1.38 inch in depth), and then fully
insert the supplied plastic anchors
(HUD 5) into them.
4. Connect the Camera connector(RJ-11)
cable to the case-rear as well as the
cable to be connected to the terminal.
Assy-case front
Screw (BH M2.6)
Eng-23
CASE-REAR
Screw
(BH M3 x 30)
Advertisement
Table of Contents
