Switching Your Pdp Display On And Off - Samsung PPM50M7F Owner's Instructions Manual

Installing Batteries in the Remote Control
1 Remove the cover on the rear of the remote control by
pressing the symbol (
remove it.
2
Install two AAA size batteries.
➢
 Make sure to match the "+" and "–" ends of the
batteries with the diagram inside the compartment.
 Do not mix battery types, i.e. alkaline and manganese.
3 Replace the cover by aligning it with the base of the remote
control and pressing it back into place.
➢
Remove the batteries and store them in a cool and dry
place if you won't be using the remote control for a long
time. The remote control can be used up to about 23 feet
from the PDP Display. (Assuming typical PDP Display
usage, the batteries last for about one year.)
➢
If the remote control doesn't work! Check the following:
1. Is the PDP Display power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power cut, or is the power cord unplugged?
5. Is there a special fluorescent light or a neon sign nearby?

Switching Your PDP Display On and Off

The mains lead is attached to the rear of the PDP Display.
1 Plug the mains lead into an appropriate socket.
➢
The main voltage is indicated on the rear of the PDP Display and the frequency is 50 or 60Hz.
2 Press the (Power) button (On/Off) on the front of the PDP Display or press the ON button on the
remote control to switch the PDP Display on.
3 To switch the PDP Display off, press the
press the OFF button on the remote control.
) downwards and then pulling firmly to
(Power) button (On/Off) on the front of the PDP Display or
English - 8