Installing Batteries In The Remote Control; Switching Your Pdp Monitor On And Off - Samsung PDP-MONITOR (PLASMADISPLAYPANEL) Owner's Instructions Manual

Installing Batteries in the Remote Control

1 Lift the cover at the back of the remote control upward as shown in the figure.
2 Install two AAA size batteries.
➢
Make sure to match the "+" and "–" ends of the batteries with the diagram
inside the compartment.
3 Close the cover as shown in the figure.
➢
Remove the batteries and store them in a cool, dry place if you won't be using
the remote control for a long time. The remote control can be used up to
about 23 feet from the PDP Monitor. (Assuming typical PDP Monitor usage,
the batteries last for about one year.)
➢
If the remote control doesn't work! Check the following:
1. Is the PDP Monitor power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power cut, or is the power cord unplugged?
5. Is there a special fluorescent light or a neon sign nearby?

Switching Your PDP Monitor On and Off

The mains lead is attached to the rear of the PDP Monitor.
1 Plug the mains lead into an appropriate socket.
➢
The main voltage is indicated on the rear of the PDP Monitor and the frequency is 50 or 60Hz.
2 Press the (Power) button (On/Off) on the front of the PDP Monitor or press the POWER ( ) button on the
remote control to switch the PDP Monitor on.
3 To switch the PDP Monitor off, press the
POWER ( ) button on the remote control.
4 To switch the PDP Monitor on, press the
the POWER ( ) button or number buttons on the remote control.
(Power) button (On/Off) on the front of the PDP Monitor or press the
(Power) button (On/Off) on the front of the PDP Monitor or press
English - 7