Connecting Vhf And Uhf Antennas - Samsung LT-P468W Owner's Instructions Manual

Connecting VHF and UHF Antennas

If your antenna has a set of leads that look like this, see "Antennas with
300-ohm Flat Twin Leads" below.
If your antenna has one lead that looks like this, see "Antennas with 75-
ohm Round Leads" on next page.
If you have two antennas, see "Separate VHF and UHF Antennas" on next
page.
Antennas with 300-ohm Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has 300-ohm twin flat leads, follow
the directions below.
Place the wires from the twin leads under the screws on
1
the 300-75 ohm adaptor (not supplied). Use a screwdriver
to tighten the screws.
2
Plug the adaptor into the VHF/UHF terminal on the bottom
of the back panel.
Antennas with 75-ohm Round Leads
If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has 300-ohm twin flat leads, follow
the directions below.
Plug the antenna lead into the VHF/UHF terminal on the
bottom of the back panel.
25