Operating Procedure - Toyota Prius Owner's Manual

OPERATING PROCEDURE

CAUTION
 When backing up, be sure to check your
surroundings and behind the vehicle for
safety, and back up slowly, depressing
the brake pedal to control vehicle speed.
 If you seem likely to hit nearby vehicles,
obstacles or people, depress the brake
pedal to stop the vehicle, then disable
the system by touching
screen.
As the system only assists with parking
in a set target parking position, there are
times when the system will be unable to
render this assistance, depending on
factors such as road surface or vehicle
condition, or the distance to the set tar-
get parking position.
Use the system with full understanding
of the fact.
If a message is displayed while maneu-
vering, follow the procedures outlined in
"WHAT TO DO WHEN THIS SORT OF
MESSAGE IS DISPLAYED" on page
343.
The illustrations here describe the pro-
cedure for pulling into a parking space
on the right. For pulling into a parking
space on the left, substitute left for right
and vice versa in all steps.
The operating method differs depending
on whether or not the pre-support func-
tion is in use.
1. INTELLIGENT PARKING ASSIST
WHEN THE PRE-SUPPORT
FUNCTION IS IN USE
1
Check that the assist mode switch is
ON.
2
With the vehicle speed at less than 15
km/h (9 mph) and the vehicle on the
near side of the parking space, press
the pre-support switch twice. Confirm
that the display has switched to the
"Backing-in mode"
on the
Press the pre-support switch twice
Sensor detection range
 The mode will switch with each press of
the pre-support switch.
 If the shift position is in
speed is 15 km/h (9 mph) or above, two
beeps will sound when the pre-support
switch is pressed, and the display will not
change. (If the shift position is in
display will not change.)
PRIUS + (EE) NAVI 47761E
screen.
" "
P or if the vehicle
9
" "
R , the
321
14.02.07 10:37