2723/#9723 Pci Ethernet Ioa (10 Mbps); 2815 Pci 155 Mbps Unshielded Twisted Pair Atm Ioa; 2816 Pci 155 Mbps Multi-Mode Fiber Oc3 Atm Ioa - IBM AS/400e User Handbook Manual

AS/400e server 250

#2723/#9723 PCI Ethernet IOA (10 Mbps)

The #9723 is a base LAN option on the Model 250.
This feature provides a single attachment to one Carrier Sense Multiple Access/Collision
Detect Local Area Network. It consists of an adapter card and internal code, which supplies
Ethernet Version 2 and IEEE 802.3 Media Access Control (MAC) plus 802.2 Logical Link
Control (LLC) functions. The Ethernet/IEEE 802.3 IOA is capable of operating in half or full
duplex mode.
The #2723/#9723 has an RJ45 connector and a 15-pin D-shell connector for attachment of
customer-supplied cabling. A vendor AUI Ethernet cable or RJ45 twisted-pair cable must be
ordered separately. RJ45 cabling for 10 Mbps must be CAT-3 or CAT-5, if CAT 5 is used,
because then it meets or exceeds Industry Standard EIA/TIA T568A or T568B. It occupies one
PCI card slot.
If #2723/#9723 Ethernet IOA is selected to be run on an #2866 Integrated Netfinity Server,
one Specify #0221 (Ethernet on Integrated Netfinity Server) is required for each #2723/#9723
ordered.
The #9723 is mutually exclusive with #9724 and #9738 as a base LAN controller.

#2815 PCI 155 Mbps Unshielded Twisted Pair ATM IOA

This feature allows the AS/400 system to be attached to an Asynchronous Transfer Mode
(ATM) network using the Unshielded Twisted Pair (UTP-5) interface. This interface is intended
for connection to both local area switches and direct connection to service provider
equipment. The #2815 is typically used where 155 Mbps speeds are required over distances
of less than 100 meters. It uses one high-speed slot, but cannot be placed in the Base
System Unit. It attaches in slot E08 and slot E03 (where #2824 is a prerequisite) of the
System Expansion Unit (#7102). Technical specifications and industry standards supported are
available at the ATM Forum Web site: The maximum is two.
http://www.atmforum.com

#2816 PCI 155 Mbps Multi-Mode Fiber OC3 ATM IOA

This feature allows the AS/400 system to be attached to an Asynchronous Transfer Mode
(ATM) network using the Multi-Mode Fiber (MMF) 62.5 micron interface. This interface is
intended for connection to both local area switches and direct connection to service provider
equipment. The #2816 is typically used where 155 Mbps speeds are required over distances
of less than 2 km. It uses one high-speed slot but cannot be placed in the Base System Unit.
It attaches in slot E08 and E03 (where #2824 is a prerequisite) of the System Expansion Unit
(#7102). Technical specifications and industry standards supported are available at the ATM
Forum Web site: The maximum is two.
http://www.atmforum.com
108
AS/400e System Handbook