Installation; Hang Mounting With Hanging Vibration Isolators; Base Mounting With Base Vibration Isolators - Greenheck MiniCore 5 Installation, Operation And Maintenance Manual

Installation

The system design and installation should follow
accepted industry practices, such as described in the
ASHRAE Handbook and SMACNA.
Minimum service clearance should be provided on
the side of the unit for routine service and component
removal should it become necessary.
Before beginning installation see page 4 for appropriate
service clearances
IMPORTANT
The MiniCore unit can be hung in any orientation. The
installation contractor is responsible for safely hang
mounting the unit to provide appropriate removal or
the access panels and unit components.
Hang Mounting
with Hanging Vibration Isolators
• The hanging isolator kit includes four (4) isolators and
required hardware.
• Locate the support rods as shown in the drawing.
• Assemble each isolator as shown below.
A
Nut
Hanger bracket,
factory-mounted
Hanging Vibration Isolator Assembly
®
B
C
MiniCore A B C
5
44.8 14 39.4
10
44.8 19.2 39.4
All dimensions are in inches.
1/2-inch threaded rod,
provided by others
Lock Washer
Flat Washer
Isolator
Flat Washer
Lock Washer
Nut
Base Mounting
with Base Vibration Isolation
• The base isolators kit includes four (4) isolators,
four (4) brackets and required hardware.
• Assemble and mount the isolators as shown in the
figures below.
Factory-mounted
bracket
3/8-inch bolt
Flat washer
Base Vibration Isolator Assembly
Assembled and Mounted Isolator Detail
Lock washer
Isolator
MiniCore 5