If A Message Is Displayed - Fujitsu TeamPad PBT7500-16 Operation Manual

8 If A Message Is Displayed...

Take action according to the "Response" if any of the following messages are displayed.
The DHCP could not obtain the IP
address. Reinsert the card, or allocate
the address manually.
An error has occurred, therefore stop
the touch panel calibration.
The server could not be connected.
Charge the battery.
An error has been detected in the
flash ROM.
No data can be saved in the flash
ROM.
The flash ROM clearing has failed.
The radio LAN driver has not been
Message
Message
Response
The DHCP could not obtain the IP address. Verify
whether or not the network has been set for the
DHCP to obtain the IP address.
Contact the network administrator if the problem
persists.
An error has occurred during the touch panel
calibration.
Tap on the [OK] button to stop the touch panel
calibration, then re-execute the touch panel
calibration.
>>Reference>> "3.6 Calibration of the Touch
Panel"
if an error occurs frequently, contact a Field support
service representative.
The connection to the server has failed. Verify the
setup settings.
>>Reference>> "3.7 Adjusting the TeamPad 7500
Setup Settings"
The residual battery capacity has become insufficient.
Charge the battery, or replace the battery with a new
one.
>>Reference>> "1.3 Battery Usage"
The set data stored in the flash ROM has been
damaged. Set up this unit again.
>>Reference>> "3.7 Adjusting the TeamPad 7500
Setup Settings"
Contact a Field support service representative if an
error occurs frequently.
No data can be written to the flash ROM. Contact a
Field support service.
The flash ROM cannot be cleared. Contact a Field
support service.
Response
The radio LAN driver has not been installed or has
42