3.6 Calibration of the LCD Touch Panel
The LCD touch panel has lost calibration accuracy if the touch panel does not respond when
tapping on the screen, or if a different portion of the touch screen is activated other than the part
which received the input.
In this case, the operation to correct the inaccuracy of the touch panel should be executed. This
operation is called "Touch Panel Calibration". There is no need to perform this calibration when
this unit is purchased, because the touch panel has been calibrated.
NOTE
•
The [PWR] key must not be pressed while the touch panel calibration tool is running.
The touch panel calibration would then need be re-executed because the setting of
touch panel calibration becomes invalid if the [PWR] key is pressed.
•
The touch panel calibration must be executed using a fully-charged battery or using
the AC adapter connected to the unit. The setup settings are initialized if the battery
capacity has become insufficient during the touch panel calibration.
•
If battery charge become low during the touch panel calibration, replace the battery,
then re-execute the touch panel calibration.
(1) Press the [PWR] key by holding on the [SYS] key while the power supply of this unit is being
turned off.
Ø The touch panel calibration screen is displayed.
(2) Tap on the [+] mark displayed on the touch panel calibration screen with a stylus.
Tap on the [Cancel] button to stop the touch panel calibration.
NOTE
The tapped [+] does not disappear if the tapped position is about 1 cm distant from the
32