Voice Memo; Record A Voice Memo - Samsung SCHU340 User Manual

Contacts — Lets you look up and display contact information for any name stored
•
in your Contacts list by saying the name. (See "Finding a Contacts Entry" on page
56 for more information.)
Status — Lets you say a single command ("Status") to check your phone's
•
network coverage, signal strength, and battery.
Note: Speaking clearly, say the command that you want to use. If, after a few seconds, the device has not
recognized a command, it prompts you to repeat the command. If, after a few more seconds, it still
has not recognized a command, it tells you "Sorry, no match found," and cancels voice recognition.
Voice Command Tips:
Make sure you wait for the beep before speaking.
•
Speak clearly at a normal volume, as if you were talking on the phone.
•
Voice-Activating Your Contacts List
When you first start VoiceSignal, it reads your Contacts list and voice-activates all
the names stored there. When you have add or change contacts, VoiceSignal
automatically reloads and voice-activates the entire list.
Ending Calls Before Restarting the VoiceSignal Software
When you use VoiceSignal to make a call, you must end that call before you can use
VoiceSignal again.

Voice Memo

You can use your phone to record voice memos for later playback. You can also
record the caller on the other end of the line during a phone conversation.
Note: There is limited space for the number and length of recordings.
The maximum number of voice memos is 10.
•
The maximum length for a single voice memo is 60 seconds.
•

Record a Voice Memo

In standby mode, press the MENU (
1.
(for Voice Kit),
@
phone prompts, "Please record after the beep."
Tip: To launch Voice Memo using a voice command — In standby mode, press the
phone prompts, "Say a command." Say "Voice Memo" into the microphone.
) key, then press
OK
(for Voice Memo), and
abc
Voice Kit
Tools),
(for
tuv tuv
for Record. The
@
key. When the
Tools 107