Installation And Uninstallation, Starting Up; Installation - Omron K6CM User Manual

4 Introduction of the Software Tool
4-2 Installation and Uninstallation, Start-
ing up
This section describes how to install and uninstall the software tool and how to start it.
4-2-1

Installation

Installing .NET Framework 3.5 SP1
The software tool requires Microsoft .NET Framework 3.5 SP1 to run the program.
If .NET Framework 3.5 SP1 is not installed on your computer, install it manually.
It is installed as a standard on Windows 7 computer. Follow steps 2 to 4 below.
It is not installed as a standard on Windows 8.1 and Windows 10 computer.
When using on a computer with Windows 8.1 or Windows 10, perform the steps 2 to 4 after installing
the .NET Framework 3.5 SP1 shown in the following step 1.
1
Install .NET Framework 3.5 SP1.
Installing by connecting the computer to the network
(1) Install it by "dotnetfx35.exe" in the Framework folder on the CD.
(2) Install the language pack with the following files in the Framework folder in the CD.
Japanese 32bit OS: "dotnetfx35langpack_x86ja.exe"
Japanese 64 Bit OS: "dotnetfx35langpack_x64ja.exe"
Installing without connecting the computer to the network
This procedure shows how to install the software tool (and attached software) on PCs (Windows 8.1
or Windows 10 OS) that cannot connect to the network.
What are required to prepare:
• Network connected computer
• Empty recording medium (USB memory of 8GB or more, HDD or DVD)
This procedure also details the resolution technique published on the following Microsoft official
website.
Microsoft official website URL:https://msdn.microsoft.com/en-US/library/windows/hard-
ware/dn898529(v=vs.85).aspx#nointerent
Note In Windows version 8.1 or later OS version, the "Microsoft .NET Framework 3.5" required for installing
the above mentioned attached software is not installed in advance. Therefore, if you are using a com-
puter with the above OS version and cannot connect to the network, you cannot acquire the above.
NET and you cannot install the software included with the software tool.
4 - 10
K6CM Motor Condition Monitoring Device User's Manual (N219)