A-10-2 Additional Status When General Status Is 01 Hex - Omron K6CM User Manual

General Sta-
tus (hex)
16 Object does not exist
17 Service fragmentation sequence
not in progress
18 No stored attribute data
19 Store operation failure
1A Routing failure (request packet
too large)
1B Routing failure (response packet
too large)
1C Missing attribute list entry data
1D Invalid attribute value list
1E Embedded service error
20 Invalid parameter
21 Write-once value or medium
already written
22 Invalid Reply Received
23-24
25 Key Failure in path
26 Path Size Invalid
27 Unexpected attribute in list
28 Invalid Member ID
29 Member not settable
2B-CF
D0-FF Reserved for Object Class and
service errors
A-10-2 Additional Status When General Status Is 01 hex
General Status Additional Sta-
(hex)
01 0100
01 0103
01 0106
01 0107
01 0108
01 0109
01 0110
K6CM Motor Condition Monitoring Device User's Manual (N219)
Status Name
The object specified does not exist in the device.
The fragmentation sequence for this service is not currently active for this
data.
The attribute data of this object was not saved prior to the requested ser-
vice.
The attribute data of this object was not saved due to a failure during the
attempt.
The service request packet was too large for transmission on a network
in the path to the destination. The routing device was forced to abort the
service.
The service response packet was too large for transmission on a network
in the path from the destination. The routing device was forced to abort
the service.
The service did not supply an attribute in a list of attributes that was
needed by the service to perform the requested behavior.
The service is returning the list of attributes supplied with status informa-
tion for those attributes that were invalid.
An embedded service resulted in an error.
A parameter associated with the request was invalid. This code is used
when a parameter does not meet the requirements of this specification
and/or the requirements defined in an Application Object Specification.
An attempt was made to write to a write-once medium (e.g. WORM drive,
PROM) that has already been written, or to modify a value that cannot be
changed once established.
An invalid reply is received (e.g. reply service code does not match the
request service code, or reply message is shorter than the minimum
expected reply size). This status code can serve for other causes of
invalid replies.
Reserved by CIP for future extensions.
The Key Segment that was included as the first segment in the path does
not match the destination module. The object specific status shall indi-
cate which part of the key check failed.
The size of the path which was sent with the Service Request is either not
large enough to allow the Request to be routed to an object or too much
routing data was included.
An attempt was made to set an attribute that is not able to be set at this
time.
The Member ID specified in the request does not exist in the specified
Class/Instance/Attribute.
A request to modify a non-modifiable member was received.
Reserved by CIP for future extensions.
This range of error codes is to be used to indicate Object Class specific
errors. Use of this range should only be performed when none of the
Error Codes presented in this table accurately reflect the error that was
encountered.
tus (hex)
Connection in Use or Duplicate Forward Open.
Transport Class and Trigger combination not supported.
Ownership Conflict.
Connection not found at target application.
Invalid Connection Type. Indicates a problem with either the Connection Type or Priority
of the Connection.
Invalid Connection Size.
Device not configured.
Description of Status
Explanation
Appendices
A
A - 47