Data Processing Flow Diagram - Agilent Technologies 8719D User Manual

If the analyzer has an active two-port measurement calibration, all
four S-parameters will be saved with the measurement results. All four
S-parameters may be viewed if the raw data array has been saved.
1. If you want to title the displayed measurement, refer to "Titling the Displayed
Measurement," located earlier in this chapter.
Choose one of the following disk drives:
a. Connect an external disk drive to the analyzer's HP-IB connector, and configure as
follows:
b. Press 1Local) ~~~~~~~~~~ and enter the drive where your disk is located,
followed by (x1).
where you want to store the instrument state fle.
e. Enter the HP-IB address of the peripheral, if the default address is incorrect
(default = 00). Follow the entry by pressing Ixl).
Figure 4-12. Data Processing Flow Diagram
Printing, Plotting, and Saving Measurement Results 4-37