Starting/Stopping - Panel Control; Forward/Reverse - Toshiba TOSVERT-130G2+ Operation Manual

8.1

Starting/Stopping - Panel Control

(FORWARD/REVERSE, Run, Coast to Stop, and Emergency Stop)
8.1.1

FORWARD/REVERSE

When wired, make sure the motor rotates in the correct direction selected by the
FORWARD/REVERSE function parameter. If it does not, then reverse two (2)
of the motor's three (3) leads to change the direction. This will ensure the motor's
correct rotation in all possible situations. The FORWARD/REVERSE function is
the first parameter in function #9. Accessing this function is illustrated in the
following table and uses the programming sequence shown below.
Function Function
No. Name
Forward/Reverse
Fault trip saving
9
Retry (Auto-reset)
Auto-restart
Regen power
ride through
Accessing the FORWARD/REVERSE Function Parameter
Key
The inverter must always be placed in the function mode
MON
before accessing any program function.
SEL
Accesses the First Function #9 parameters.
9
READ
Displays the current "F.r." setting.
new value Should a new value be necessary, it can be set by entering the
new value followed by the WRT command.
WRT
Returns to the inverter's monitor mode. Assumming the
MON
inverter is not running the display will read "0.0".
6
Starting the inverter via the panel requires first entering a
0
specified run frequency followed by the WRT command.
Example 60Hz
WRT
Engages the run command. The inverter's output frequency
will "ramp up" to 60Hz, causing the motor to accelerate to its
RUN
60Hz speed.
Engages the stop command. The inverter's output frequency
STOP
will "ramp down" to 0Hz, causing the motor to decelerate
to a stop.
First Function Parameters
Adjustment
Display Range
0: Reverse
1: Forward
0: Cleared when powered off
1: Data retained when powered off
0: Off
1: On
0: Off
1: On
0: Off
1: On
Action
:[new value]
8 - 3
Factory Error
Set Message
1
0
0
0
0
:[new value]
:[new value]
TOSHIBA
Ref.
Page
8-24
8-24
8-24
8-25
8-25
Display
:[value]