Function Access/Set Methods; First Functions - Toshiba TOSVERT-130G2+ Operation Manual

7.3

Function Access/Set Methods

7.3.1

First Functions

Accessing and setting the first functions are accomplished by using the
following procedure. The example below illustrates how to access, read,
and set the ACC/DEC file, which is located in First Function #2.
Function Function
No. Name
Acceleration time #1
Deceleration time #1
Acc/Dec #1 pattern
2 Acceleration time #2
Deceleration time #2
Acc/Dec #2 pattern
Acc/Dec #1, #2 select
Key
The inverter must always be placed in the function mode
MON
before accessing any function.
ACC/DEC The function parameter ACC1 will be displayed. This means that
the ACC1 parameter has been accessed.
2
READ
Reads and displays the current value assigned to ACC1.
5
The ACC1 parameter is set to 5.5 seconds. The display will
flash "5.5" and "ACC1" indicating the setting has been made.
.
5
WRT
The parameter can also be changed by using the scroll keys
"up"
key should be pressed to set the new value.
WRT
The next parameter within the ACC/DEC file is accessed (dec1)
NEXT
The next parameter within the ACC/DEC file is accessed (Pt.1)
NEXT
MON
Returns to the monitor mode.
Note:
Continued "pressing" or "holding down" of the NEXT key causes the inverter to
cycle through the entire function currently accessed. For the above example the
inverter would cycle through and display the following parameters: ":ACC1",
":dec1", ":Pt.1", ":ACC2", ":dec2", ":Pt.2", and ":Sel2".
Function Parameters
Adjustment
Display Range
0.1 to 6000
0.1 to 6000
0: Linear
1: S-curve
2: C-curve
0.1 to 6000
0.1 to 6000
0: Linear
1: S-curve
2: C-curve
0: Acc/Dec #1
1: Acc/Dec #2
Accessing First Functions
Action
or "down" . When 7.5 has been reached the WRT
Unit
sec
sec
sec
sec
7 - 3
TOSHIBA
Factory Error Ref.
Set Message Page
10 8-21
10 8-21
0 8-21
10 8-21
10 8-21
1 8-21
0 8-21
Display