Table of Contents
Advertisement
If automatic white balance adjustment cannot be made
If the white balance adjustment cannot be completed normally, an error
message will appear for about 3 seconds on the viewfinder screen (in
display mode 2 or 3).
Possible messages are listed below.
Error message
WHITE : NG
4
LOW LEVEL
WHITE : NG
COLOR TEMP. HIGH
WHITE : NG
COLOR TEMP. LOW
WHITE : NG
TIME LIMIT
WHITE : NG
POOR WHITE AREA
WHITE : NG
LEVEL TOO HIGH
If any of the above error messages is displayed, retry the white balance
adjustment. If the error message occurs again, an internal check is
necessary.
Refer to "maintenance manual" for information about this internal check.
4-10
Chapter 4 Adjustments and Settings for Recording
White balance adjustment error messages
The white video level is too low. Either make
open the lens iris or increase the gain.
The color temperature is too high. Select a
suitable filter setting.
The color temperature is too low. Select a
suitable filter setting.
Adjustment could not be completed within the
standard number of attempts.
The white area could not be checked.
The white video level is too high. Either narrow
the lens iris opening or change the ND filter.
Meaning
Advertisement
Table of Contents
