Connect A Console - Lucent Technologies PortMaster PM-2 Hardware Installation Manual

4. Connect a Console

All PortMaster Communications Servers have an ansyncronous port designated the
console port. On ISDN models the console port is C0. On all other models it is S0.
Follow these instructions to connect a console.
Required Equipment
DB-25 male-to-male serial null modem cable, with a 25-to-9-pin female adapter if
you are using a PC. (See "Male-to-Male Null Modem Cable" on page B-2 for pinout
information.)
This cable and adapter are available from most computer equipment suppliers.
PC or terminal
Procedure
1. Attach one end of the cable to the PortMaster console port, and attach the other
end to the serial port of a PC or terminal.
–
–
Installing the PortMaster
S0 console port (PM-2 rear panel shown)
S0
S0
S5
C0 console port (PM-2i-U rear panel shown)
ISDN/U ISDN/U
S0-S1 S2-S3
C0 - DIAG
C0 - DIAG
S1 S2 S3 S4
S6 S7 S8 S9
P0 ETHERNET
1187-0001
ISDN/U ISDN/U ISDN/U ISDN/U
S4-S5 S6-S7 S8-S9 HD
ETHERNET
1187-0002
Connect a Console
2-7