Lucent Technologies PortMaster PM-2 Hardware Installation Manual page 47

–
9. Attach the rear face plates with the screws provided.
Ensure that each face plate is aligned before tightening the screws.
10. Plug the 8-wire ribbon power cable and 60-wire ribbon bus cable into the front
of each expansion board.
60-wire ribbon bus cable
11. Replace the lid of the PortMaster case, and using a Phillips screwdriver, replace
the screw.
12. Connect the PortMaster to the power source and turn the power switch on.
Installing Optional Equipment
S20 through S29 expansion board. Insert this expansion directly board above
the rear face plate containing ports S10 through S19.
S0
S5
1187-0037
S20
S25
ISDN/U ISDN/U
S10-S11 S12-S13
S0
S5
Installing PortMaster Expansion Boards
S1 S2 S3 S4
S6 S7 S8 S9
RS-232
W1 V.35 ETHERNET
1187_0029
1 2 3
S21 S22 S23 S24
S26 S27 S28 S29
ISDN/U ISDN/U ISDN/U ISDN/U
S14-S15 S16-S17 S18-S19 HD
S1 S2 S3 S4
S6 S7 S8 S9
RS-232
1187-0022
V.35
W1 ETHERNET
1187_0031
1187_0031
S20 through S29
S10 through S19
8-wire ribbon power cable
3-9