Lucent Technologies PortMaster PM-2 Hardware Installation Manual page 35

–
4. If you are using a 10Base2 (BNC) Ethernet connection, verify the following:
–
–
5. If you are using a 10Base5 (AUI) Ethernet connection, verify the following:
–
–
6. If you are using a 10BaseT Ethernet connection, verify the following:
–
–
Installing the PortMaster
S/T interface. The BRI status LED flashes once at startup and then stays solidly
lit for an active link (PM-2i shown).
ISDN/ST ISDN/ST
S0-S1 S2-S3
C0 - DIAG
Link LED. Flashes once at startup
Network LED. Flashes when Ethernet traffic is present
Link LED. Flashes once at startup
Network LED. Flashes when Ethernet traffic is present
Link LED. Flashes twice at startup
Network LED. Flashes when Ethernet traffic is present
ISDN/ST ISDN/ST
S0-S1 S2-S3
C0 - DIAG
1189-0016
link LED
network LED
1187_0016
ISDN/ST
S8-S9
ISDN/ST ISDN/ST ISDN/ST
S4-S5 S6-S7 S8-S9
ETHERNET
1189-0015
ISDN/ST ISDN/ST ISDN/ST
S4-S5 S6-S7 S8-S9
ETHERNET
ETHERNET
Turn On Power
BRI Status LED
2-15