Ac Power Cord; Printer Cable (Sf-5100P Only) - Samsung SF 5100 User Manual

02-Installation 12/10/99 6:28 AM
1.8
Installation
Page 10
Power cord
Plug one end of the cord into the back of the machine and the other
end into a standard AC power outlet.
The machine will turn on and the display will show 'SYSTEM INITIAL'.
If there is no cartridge installed or no paper, the display will show
'JAM/NO CARTRIDGE' or 'NO PAPER'.
To AC
outlet
If you want to turn it off, unplug the power cord.

Printer cable (SF-5100P only)

Your SF-5100P has a parallel interface port, which allows you to use it
with IBM PC and compatible computers.
To connect the printer to the computer, follow the steps below:
1. Make sure that both the SF-5100P and the computer are turned off.
2. Plug the cable into the connector on the back of the SF-5100P. Push
the metal clips down to fit inside the notches on the cable plug.
3. Connect the other end of the cable to the parallel interface port on
your computer. See your computer documentation if you need help.
Note: There is a parallel port on SF-5100, but it does not work.